Cold Storage Construction
in Telangana

The envelope is what decides whether a cold storage stays cold — or bleeds energy and product losses every day. We use factory-bonded polyurethane (PUF) panels sized to the chamber temperature — thicker sections for freezer rooms, standard sections for chill rooms — with proper vapour barriers and cold-tight doors. Every joint is sealed, gasketed, and inspected before commissioning.

• 80–200mm PUF panel thickness matched to chamber temp
• Factory-bonded, non-CFC insulation core
• Sliding, hinged, and traffic doors with heater strips
• Vapour barrier detailing at floor, wall, and ceiling joints
• Anti-fungal food-grade panel skin options
• Floor insulation and RCC slab detailing for freezer chambers

Refrigeration selection depends on the product, chamber size, and the temperature range you need to hold in Telangana's hot summers. We size compressor racks, evaporator coils, and condenser units for the peak-summer heat load — not just the average — so the plant runs efficiently in April and May, when most under-sized cold storages fail. Every install is commissioned with logged pull-down tests.

• Ammonia, Freon, and CO2 refrigeration system options
• Chambers from +15°C down to −25°C
• PLC-based temperature and humidity controls
• Redundant compressor sizing for uptime
• Energy-efficient evaporator fans and defrost controls
• Remote monitoring and alarm systems

Most cold storage clients in Telangana handle more than one commodity — mango pulp in one season, chillies or turmeric in another, dairy year-round. We design chambers around your commodity mix, with separate temperature zones, hygienic segregation for food-grade product, and clean loading/unloading circulation so cross-contamination never becomes an issue.

• Independently controlled multi-chamber layouts
• Ante-rooms and dock-levellers for temperature buffering
• Racking and pallet-flow storage design
• Separate zones for raw, processed, and packaged goods
• Truck-turning circles and covered loading bays
• Sanitation and washdown-ready floor finishes

A cold storage that isn't compliant can't sell to the buyers that pay the best rates — organised retail, export houses, pharma majors. From day one we build to FSSAI, APEDA, and where relevant NCCD/NHB subsidy specifications, with documentation trails at every stage so audits, inspections, and subsidy claims go through without back-and-forth.

• FSSAI food-grade construction and finish standards
• APEDA export-grade cold chain compliance
• NHB / NCCD subsidy documentation support
• Fire NOC and pollution board compliance
• As-built drawings and MEP schematics
• Third-party thermal validation and calibration

A cold storage is a piece of live machinery — it needs trained operators and a maintenance discipline from day one. We hand over with commissioning reports, operator training, and documented SOPs for daily monitoring, defrost cycles, and emergency shutdowns. Post-handover, we stay reachable for refrigeration AMC, panel repair, and expansion work as your capacity grows.

• Documented commissioning and pull-down tests
• Operator training and SOPs for daily operations
• Refrigeration AMC and preventive maintenance packages
• Warranty on panels, doors, and refrigeration equipment
• Emergency call-out for chamber failures
• Capacity expansion and retrofit support